Zipper Repairs
Replace A Broken Zipper Slider
-
-
Step 1:
Select a slider that matches the one you are removing. The letters that are printed on the slide tell you what size you need. With a seam ripper, carefully remove stitching around lower ends of zipper tapes. Pry off metal stop at bottom of the zipper, careful not to tear the tapes at the base of the zipper teeth
-
Step 2:
Remove old zipper foot. Take new zipper slider and guide track tapes into the top grooves of the slider, pushing them through to the bottom. Use a pin if needed to work the track tapes through. Pull tapes gently to make sure slider is sitting evenly on tracks. With both tapes threaded through slider, gently pull slider up until locked track teeth appear at bottom.
-
Step 3:
Sew a new stop at bottom of the tracks with needle and thread. Sew zipper back onto garment where stitching was removed for repair.
Find more great tips like these in our Repair Guide
-
Re-coat worn areas on your tent floor with Tent Sure™ Tent Floor Sealant. Apply to the coated side of the fabric (the inside) using a foam paintbrush. For best results apply Tent Sure in a thin film, using even, sweeping motions to avoid puddles. A single thin coat works best.
-
To sharpen a knife, slide the knife across the sharpening stone as though you are trying to cut a thin slice off the stone. Hold the blade at roughly a 20 degree angle and draw it steadily. Be sure to count the number of strokes and do the same number of strokes on the opposite side.